1:144 Dragon A-6 Intruder

1
March 3, 2024
2
March 3, 2024
3
March 29, 2024
The painting of the cockpit and the primer are finished. Kit seats on the right, aftermarket on the left.
4
March 31, 2024
5
March 31, 2024
6
March 31, 2024
7
March 31, 2024
8
March 31, 2024
9
April 2, 2024
10
April 12, 2024
Environmental Control System ram air intake from sprue
11
April 12, 2024
GBU-10 from Revell F-15E kit
12
April 12, 2024
GBU-10 from Revell F-15E kit
13
April 17, 2024
First I glued the smaller bombs on the triple ejector racks. Then I put the central fuel tank in place, followed by the GBU-10s on the outer pilons. After that I glued the landing gear doors and finally the two complete racks with the 5-5 Mk 82s on the inner pilons.
14
April 25, 2024
15
April 25, 2024
16
April 25, 2024
17
April 25, 2024
18
April 25, 2024
19
April 25, 2024
20
May 6, 2024
21
May 6, 2024
22
May 6, 2024
23
May 6, 2024

Kommentare

46 3 March 2024, 15:49

Spanjaard
i am in 🙂

4 March 2024, 14:52

Freak
You do know how to create anticipation, putting a detailed cockpit into a 1:144 A-6.

4 March 2024, 21:33

Mike Volkov Autor
The cockpit is a product of RetroWings. 😊 The cut was a little bigger than it should have been. 😅 I use Tamiya Epoxy Putty, then when it has set, I paint it.

5 March 2024, 08:16

Freak
Lovely progress pictures! I'm taking notes on how to layer a US Navy plane, this is a masterclass!

2 April 2024, 06:38

Mike Volkov Autor
Thank you Freak! I hope it is useful. 😊

2 April 2024, 08:50