Ford Puma - Rally Monte Carlo 2002 - Reference pics

1
May 30, 2015
As usual, I start bu cleaning up the main bodyparts, removing all the flash and other unwanted castings.
2
May 30, 2015
Next I dry fit the chassis, body, safety rollcage and wheels to see if there are any unforseen problems. So far so good.
3
May 31, 2015
Next I trim and adjust the rearview mirrors and I replace the resin support of the rear wing by some photo etched leftovers because it was too fragile to handle.
4
June 1, 2015
Next I give the body a grey primer coat. Once the primer is dry I start by spraying the front of the body with Tamiya TS-18 Metallic Red. The yellow dotted line indicates to where the red should come, the rest of the car will be metallic blue.
5
June 1, 2015
So now I will have to wait until the red paint is dry, then I will mask the red area, after which I will spray the blue area. To be continued 😉
6
June 2, 2015
Once the metallic red paint is dry, I mask the body with BMF and Tamiya masking tape.
7
June 2, 2015
The interior of the body was masked as well, to avoid blue overspray into the red areas.
8
June 2, 2015
Next the metallic blue layer is airbrushed on the body.
9
June 2, 2015
As soon as the paint is dry, the masking is removed. The paint looks a lot better in reality compared to the pictures, where the metallic particles reflect too much.
10
June 2, 2015
Dry fit of the Puma with the main (airbrushed) bodyparts.
11
June 2, 2015
It starts to look like a Ford Puma now 😉
12
June 6, 2015
So now I fixed all the decals on the car.
13
June 6, 2015
Obviously, this Ford didn't have a lot of sponsors...
14
June 25, 2015
Next I built up the interior. The non-existing safety belts wre scratchbuilt.
15
June 25, 2015
I had to sand off a part of the safety roll cage because otherwise the interior didn't fit into the body...
16
June 25, 2015
The construction of the body itself was also continued.
17
June 25, 2015
The headlights and windows were fixed to the body as well.
18
June 25, 2015
The remaining parts were detail painted and prepared; all what's left to do now is fix them to the body of the car and install te last details.
19
June 25, 2015
So this is how the Puma looks like with all the main parts fixed, before the final details have been installed.
20
June 25, 2015
From here on it's straith to the finish line of completion 😉