Hughes TH-55A Osage

Special Hobby | N. SH72016 | 1:72

I fatti

Marca:

Special Hobby

Titolo:

Hughes TH-55A Osage

Numero:

SH72016

Scala:

1:72

Digita:

Kit completo

Messo in commercio:

1998 Nuovo stampo

Argomento:

Hughes 300 » Elicotteri (Aereo)

Insegne

Hughes 300

• D-HFAB

• G-SHCB

Hughes Hkp 5

Svenska Flygvapnet (Swedish Air Force 1926-now)

• 40
  1988

Hughes TH-55A Osage

航空自衛隊 (Japan Air Self-Defense Force 1954-now)

• 61317

US Army Aviation (1947-1983)

• 18126
  1964

Contenuto della confezione

Plastic sprue, Fotoincisioni, Resin (cast), Vacuformed, Film fotografico, Foglio di decals (applicabile con acqua)

Genealogia

 

Special Hobby

1998

Nuovo stampo

Istruzioni

Scaricare 1019Kb (.pdf)

Mercato

Commercio e scambio privati

EUR 30.00

Contatta il venditore

Nota: Prezzi e disponibilità sono solo indicazioni. Controlla anche che il prodotto corrisponda effettivamente!

Recensioni in-box

Revisioni esterne

Collegamento non funzionante

Internet Modeler

Riviste

FineScale Modeler | Volume 17 Issue 9

English (TOC: 16 lines)

November 1999

Commenti

DavidS
I was presented with this kit many years ago. Never managed to finish it. In particular, I could not figure out how to attach the resin interior to the vacuformed body. Then again, I am not a skilled modeler.

Also, I found that the interior was not accurate. The instrument panel does not resemble the pictures I found on the internet.

In my opinion, this is not a kit for beginners.

2 May 2020, 07:23

Gertjan Zwart
Very nice little kit of a not too common modelling subject. The injection moulded parts (struts and tubular landing gear stuff) imho are oversized. Since they are all simple and straight, I replaced them by Evergreen plastic rods. Other injection moulded parts are gas tanks and engine lay out and these are usable. The cockpit interior is fairly basic and detailing is up to the modeller. The cockpit bubble consists of two vacuformed halves that line up vertically in the middle of the cockpit. I am by no means an experienced multi media- modeller but I had relatively minor problems cutting, trimming and glueing these pieces into an acceptable cockpit.

10 January 2013, 09:02