STZ-5

The finished model. The base is a mixture of plaster and sand. The fence is made of pine timber cut into slats. The figures are 3D printed (the tractor driver and the cat were bought in a store, the crow was printed myself from a file bought on myminifactory). 

What's going on?
(a) The Cat gives the tractor driver directions. "How to drive to communism."
(b) The tractor driver sends the Cat greetings from the Cat's newborn kittens.
(c) The tractor driver distracts the Cat the guardian, and the Crow prepares to steal valuables.
(d) The Cat hunts the Crow, the tractor driver distracts the Cat and saves the Crow
(e) Something else - write in the comments. 

The firewood is made from branches. The full trunk is made from only 15 centimeters of branch. Not much. 

 

The tractor driver is in 1:35 scale, but in order for him to enter the cabin, it was necessary to change the seat (on the seat from the box, the driver's head was higher than the roof of the tractor) 

You can drive, but it’s uncomfortable without a windshield and a roof. 

 

 

This model has a very detailed engine, which is not visible after assembly. 

 

 

This time I bought a box for the model in a store. The pros are that the walls are much thinner. The cons are that the walls get dirty easily, they are not completely transparent and overlap each other. 8(