bossy122
Be really careful when putting the wheels on the suspensions. I snapped a front suspension arm as the wheel stemWOULD NOT go into that 1/24 scale rubber gasket.

Michael Kohl
Love the lines of the old Formula 1 race cars. Following.

Sam L Author
@bossy122 thanks for the note on the rubber washers, I will be steady when that part comes!!!!
@Michael Kohl thanks for the follow! I hope you enjoy my updates

Marcel
Fantastic result. It looks flawless. Nigel looks ready to race this car. 🙂

bossy122
That came out quite nicely. Wouldn't it be nice if someone would make some sharper exhausts in 3D? ( hint hint). Did you have any problems with those wheel gaskets?

Sam L Author
@bossy it certainly would be nice for some 3d printed exhausts! With some printed weld lines would be even nicer! (hint hint). No problems for me with the wheel gaskets as I thinned them down a little before attempting to place them, thought I might only have one shot at it!!