Thread started by Mr D
Mr D??? Hi all ???
I'm having a go at panel lines and weathering for first time on my IAR-80 model.
Can anyone advise at what stage do l add the chipping effect??
Is it before or after the Final flat coat ??
Any advice be appreciated 👍👍👍
I'm having a go at panel lines and weathering for first time on my IAR-80 model.
Can anyone advise at what stage do l add the chipping effect??
Is it before or after the Final flat coat ??
Any advice be appreciated 👍👍👍
12 October 2024, 14:15
SpanjaardI guess it depends of the level of chipping and the metod used. if you add (light) chipping with sponge, that will be almost the last thing you do, and if you use chipping fluids, you have to use them between layers of paint (certainly before last camo layer)
but I am certainly not expert un the subject!! 🙂
12 October 2024, 14:20
Mr D AuthorThanks Spanjard 👍👍
It's going to just be a little bit with a sponge,
Thanks, lve done panel lines and probably do some oil run's next l will flat clear then n do chips after.😃👍
12 October 2024, 14:31
DuperScaleI used chipping fluid once and it is pretty easy. I sprayed a WW2 German red primer on my tank. Then the fluid and on top the camo. Then with a wet brush i could easy chip the camo. Then i sealed all with varnish
12 October 2024, 14:43