WIP

Nathan Dempsey
Huge project! Looks really nice!

Tom Beighley
An epic build!

Vesa-Pekka Palmu Autor
And finally after ~7 years since the first packet it is coming together 🙂

Holger Kranich
Niiiiicccceee!

Mike Powers
I just brought my kit getting ready to start the fine details of the interior spaces. Any suggestions on how to open up the hull to fit in the components would be very helpful.
Thanks
Rescueranger
Aka
Mike Powers

Vesa-Pekka Palmu Autor
I used a proxon rotary tool for the rough cutting and then CMK razor saws, files and sanding sticks to fine-tune. Was the most nervous part of the project

Vesa-Pekka Palmu Autor
Should also be doable without powertools with a jigsaw or just razor saws

Mike Powers
Did the CMK kits provide a diagram of where to make your cuts?
This is were it's nerve racking as I'm sure it was for you, you spend a couple hundred on the kit the last thing you want to do is botch the job before you even start. I have also thought of having the left side of the hull cast in clear plexiglass or vacuum formed not sure if that could be an option or even if it is the cost would be worth it. Comunity and your thoughts.
Now that I think about it, if perhaps I commissioned the fabrication of several of them I could sell them as an aftermarket kit to help offset the initial costs of the fabrication.

Łukasz Gliński
That's epic indeed 👍

Vesa-Pekka Palmu Autor
The CMK kits include instructions on where to cut, I made the cuts way smaller than suggested at the start and proceeded to check and enlarge.

Mike Powers
thank you Vesa I am feeling a bit better about cutting into it now if I can not get a clear form fitting

Steven Van Dyck
I photographed this model 2 years ago at BSMC, maybe it can be of some help? [img1]

Vesa-Pekka Palmu Autor
One thing I also thought about was to first drill few holes and make sure the locations are right, but didn't end up doing that

Mike Powers
This is great stuff guys and I appreciate it all.
We spend good hard earned money on our hobbies and the last thing you want to do is hose up a project, even before it has a chance to get going.