Hughes TH-55A Osage

Special Hobby | No. SH72016 | 1:72

Чињенице

Бренд:

Special Hobby

Наслов:

Hughes TH-55A Osage

Број:

SH72016

Размера:

1:72

Тип:

Целовита макета

Издато:

1998 Нови алат

Тематика:

Hughes 300 » Хеликоптери (Летелице)

Ознаке

Hughes 300

• D-HFAB

• G-SHCB

Hughes Hkp 5

Svenska Flygvapnet (Swedish Air Force 1926-now)

• 40
  1988

Hughes TH-55A Osage

航空自衛隊 (Japan Air Self-Defense Force 1954-now)

• 61317

US Army Aviation (1947-1983)

• 18126
  1964

Садржај кутије

Пластична смрека, Пхотоетцхед фрет, Смола (ливена), Усисавани, Фото филм, Децалсхеет (водени тобоган)

Временски оквир производа

 

Special Hobby

1998

Нови алат

Упутства

Преузимање 1019Kb (.pdf)

Тржиште

Приватна трговина и размена

EUR 30.00

Контактирај продавца

Белешка: Цене и доступност су само информационог типа. Такође проверити да ли се производ подудара!

In-box рецензије

Екстерне рецензије

Прекинута веза

Internet Modeler

Часописи

FineScale Modeler | Volume 17 Issue 9

English (TOC: 16 lines)

November 1999

Коментари

DavidS
I was presented with this kit many years ago. Never managed to finish it. In particular, I could not figure out how to attach the resin interior to the vacuformed body. Then again, I am not a skilled modeler.

Also, I found that the interior was not accurate. The instrument panel does not resemble the pictures I found on the internet.

In my opinion, this is not a kit for beginners.

2 May 2020, 07:23

Gertjan Zwart
Very nice little kit of a not too common modelling subject. The injection moulded parts (struts and tubular landing gear stuff) imho are oversized. Since they are all simple and straight, I replaced them by Evergreen plastic rods. Other injection moulded parts are gas tanks and engine lay out and these are usable. The cockpit interior is fairly basic and detailing is up to the modeller. The cockpit bubble consists of two vacuformed halves that line up vertically in the middle of the cockpit. I am by no means an experienced multi media- modeller but I had relatively minor problems cutting, trimming and glueing these pieces into an acceptable cockpit.

10 January 2013, 09:02