DerMattes
Watching! Could you give some information how you made the decals? Printer, paper, workflow? Thank you!

Jennifer Franklin
following 👀

Nicolas
Following

Amenofys Аутор
I scanned the flat parts like wings, elevators and tail rudders and combined them with blueprints from the internet. I used this as a base and then, in Adobe Illustrator, drew the camouflage areas. On the curved parts, like the bow, I first attached pieces of masking paper and marked the contours with a pencil. I then peeled off the masking paper and attached it to a flat piece of cardboard which I then scanned. I used that as a base to draw the corresponding camouflage areas in Illustrator. Finally, I printed all the camouflage areas on blank decal paper with a laser printer. I used the clear one. As the base color of the fuselage is not white but light gray and I used clear decal paper, I colored the camouflage areas in a slightly lighter tone than the real one, taking into account that it would darken slightly with the light gray background. I hope it helps, DerMattes.

Amenofys Аутор
I used the decal paper, the decal fixer and decal softener from Greenstuff World. It doesn't need a varnish coat after printing.

DerMattes
That helps a lot, that you for taking the time to explain! 👍

Amenofys Аутор
you are welcome 🙂

Amenofys Аутор
After a break, the project is finished. I am very happy with how the camouflage turned out using the homemade decals. The cockpit left huge gaps with the fuselage in the hinge area, so I have chosen to place it in the open position (even though the cockpit is quite sparse).

Amenofys Аутор
Thanks for the likes and following.

Nicolas
Nice result. 👍👍

Amenofys Аутор
Thank you Nicolas 🙂