Ścianka

knubbels
dodał nowy album.

knubbels
dodał nowy projekt.

knubbels
and schoblobloch are now mates.

knubbels
In case anyone just wants the LaserCut model of the Reichstag without the "plastic" the manufacturer is called "Sarissa-Precision" (in the UK).
They do all the LaserCut models for Italeri incl. "full-sized" front of the "Reichstag" with all five "arched wings" instead of just three.
This is the link for the "five-wing-arched" version:
sarissa-precision.co..riant=42468460101850

knubbels
360° view of the finished model can be found here
3dmetalmodel.com/3d/C21106/

knubbels
this set also exists as 1:72 scale (LYTG72900)

knubbels
The Dragon Panzer III Ausf. L (7645) contains all the parts needed to construct the Ausf. M:
-deep wading exhaust and flaps under rear overhang (parts 2, 3, 6, 9) "sprue b" (incorrectly labeled "F" in the instructions)
-sealed brake maintenance hatch in front plate "sprue b part 10"
-sealed engine air intakes "sprue b parts 7 & 8"
-newer model idler adjustment at the rear "sprue b parts 11 - 14"
-Bosch lamp, water-tight "sprue b parts 4 & 5" ==> use only 1x!
-no side exit doors in the hull ==> the adjustment frames molded in the hull need to be removed
!!! beware that quite a lot of the parts of "sprue b" are not shown in the manual but can be found in the kit and in the manual of the older version of this kit Dragon 7290

knubbels
dodał nowy projekt.

knubbels
dodał nowy projekt.

knubbels
dodał nowy album.

knubbels
dodał nowy album.

knubbels
dodał nowy album.

knubbels
dodał nowy projekt.

knubbels
Beware, it maybe that the mesh for the rear engine hatch is not part of the set (missing in mine)