Стена
Wall
February 27, 2025
February 14, 2025
February 4, 2025

добавил новый фотоальбом.
15 20 December 2024, 20:38

Great job! (I am impressed, that you managed to put these stiff decals so perfectly...)
4 February, 14:18
January 31, 2025
January 22, 2025
January 21, 2025
November 10, 2024
November 4, 2024
October 19, 2024
September 11, 2024
September 4, 2024

Would anyone be willing to sell or trade Caracal's F-101B Voodoo Air National Guard decal set in 1/72 (CD72011)?
There are only a handful of decal sets in my stash that I'd be unwilling to part with if you're interested in a straight trade. I want to build the Maine ANG version, so I'd also be happy to trade for a partial set if you were planning to build one of the other airframes. I have all of the stencils and insignia I need; I only need the unit-specific decals.
I have the Maine ANG decal sheet in 1/72 by Check Six!, but it's slightly out of register. I've been looking for the Caracal sheet for a long time, and it's just nowhere to be found. Thanks to you all!
There are only a handful of decal sets in my stash that I'd be unwilling to part with if you're interested in a straight trade. I want to build the Maine ANG version, so I'd also be happy to trade for a partial set if you were planning to build one of the other airframes. I have all of the stencils and insignia I need; I only need the unit-specific decals.
I have the Maine ANG decal sheet in 1/72 by Check Six!, but it's slightly out of register. I've been looking for the Caracal sheet for a long time, and it's just nowhere to be found. Thanks to you all!
4 September 2024, 15:04
August 26, 2024
August 24, 2024
August 22, 2024

добавил новый фотоальбом.
Все комментарии (49) » 79 9 January 2024, 00:44

@treehugger, the Dspiae tool can be hard to dial in... it takes a fair bit of trial and error. The marks can help get you in the neighborhood, but I find I need to do several test cuts before I get it just the right size. The good part is that once you've got it, you can cut as many as you need. That's usually at least four, so it ends up being a time saver, and the results are great. Getting the blade tension right also takes some practice, though you quickly get a feel for that.
22 August 2024, 15:29

Agree with Ogre on the Dspiae tool - only thing to add is make sure you cut it on a hard surface, not a rubber mat
22 August 2024, 17:56
August 20, 2024
August 16, 2024
August 13, 2024
May 19, 2024
May 11, 2024
May 10, 2024
April 21, 2024
wnolder.php?lang=ru
2024-04-21 06:46:07
2022-09-04 22:53:03
117938
/ajax/wnolder.php?lang=ru&sd=2024-04-21 06:46:07&md=2022-09-04 22:53:03&filter=&w=117938
todo