HA-1.112-K1L Buchón 1:32

 

 

 

 

good fit in the 3d printed parts 

Interior parts specifically designed for this buchon 

Gunsight 

Main panel, note the detail achieved.... but I'm not sure if I would be able to paint it
 

Rocket launcher box 

 

printed parts in place 

 

 

 

 

 

aded some detail in the ruder pedals 

 

Some wires to add detail 

instrument panel and rocket box almost painted 

 

 

panel ready 

 

Rocket launcher box ready
 

starting to play with interiors
 

need some washes but is close to finish 

 

 

 

 

internal face of the canopy painted in interior colour 

Cockpit weathered 

 

 

 

 

3d printed Buckles for the seatbelts 

 

seatbelts made with thin metal foil and the 3d printed buckles 

 

 

 

 

 

 

dry test fit of the nose
 

 

 

 

thinlayer of paint to unify colours and check for imperfections 

 

quine nice here 

some minor imperfections on the panel lines should be repaired 

 

the stitching on the rudder seems too big, I will sand it down a bit to improve it
 

Riveting all the parts 

 

 

 

 

wings riveted 

Photo Etched parts installed and guns in place 

Top side, fences also glued, made of evergeen plastoc board