Maus 1/100

Zsolt Czegle autor
Base color and camo with color modulation airbrushed.

Stefan Schacht
Very nice 👍, I am in.

Zsolt Czegle autor
Danke Stefan! Inzwischen habe ich das Balkenkreuz angemalt.

Zsolt Czegle autor
All dots are airbrushed, waiting for warnish.

Zsolt Czegle autor
Let's begin with the weathering......

Andreas Koziol
looks fantastic! 👍

Zsolt Czegle autor
Thank you Andreas! It's still only ca. 85% done.....

Zsolt Czegle autor
I say it's completed now! I'm very statisfied with the result! 🙂

Andreas Koziol
impressive 1/100 skills! 👍

Stefan Schacht
very nice result 👍

Zsolt Czegle autor
Danke Stefan und Andreas!

Bart Goesaert
nice tiny little giant...

Random Penguin
Nice!

Zsolt Czegle autor
Thank you Bart and Robber!

Hekafi1932
Amazing!

Maarten Henderieckx
beautiful work for this scale

Zsolt Czegle autor
Thank you Otto and Maarten!

Hekafi1932
This looks great! Were decals included in the kit?

Zsolt Czegle autor
Thanks! Check the photo Nr.13. The Balkenkreuz is masked and airbrushed. There are no decals included.

Hekafi1932
Thank you, I just got the same kit and I was worried. Would you mind uploading the image of all the paints you used to the photo album? The quality of the preview isn't good enough to make out exactly what you used.

Zsolt Czegle autor
Used AK acrylics: Turret:AK127 and AK129 (Red Primer) , the Hull: AK 713, AK714 (both Dunkelgeb) and AK 715 (Resedagrün)

Hekafi1932
Thank you. I am building this kit myself, however there is a very small, but noticeable gap between the turret and the hull. If i press down on it very hard it seals, but it'll oftentimes "pop up" again. How do I close this gap without removing my ability of being able to turn the turret?

Spanjaard
beautiful

Bart Goesaert
making enough room for it to sit flush? (scraping paint away on contact surfaces. Always better to check this before painting. When you turn the turret a few times, do you see specific paintdamage in the area? This can be usefull to determine what to do... or where to remove paint

Zsolt Czegle autor
Thank you Spanjaard!

OttovonLindberg: Bart has right! Make the hole on the turret a little bit bigger. So it won't pop up anymore.

Hekafi1932
Hi Bart, I have not yet painted the model.

Hi Zsolt, thanks, I will try that. I sanded down the turret bottom some, and it didn't seem to help

Bart Goesaert
Did you sand the vertical surfaces? On the bare plastic you dan also see the friction marks.

Hekafi1932
I have sanded down the turret bottom with a 160 grit sanding file. Looking at the upper hull, I do see two rings where it seems the turret cut into the plastic (the friction marks you're referring to).

Zsolt Czegle autor
OttovonLindberg upload photos about your build into your project's album. So we can see your photos and so we coud help you! 🙂